Hello all, I have a problem with my Punto Evo 1.3 M-jet from 2011. My brake lights wont turn on when I am braking. It happened a couple of times in the past. I found out that fuse 11 in the dashboard fuse box (INT supply for instrument panel, switch on brake pedal (N.O. contact), third brake P0101 code in the Fiat Punto is crucial to maintaining your truck's performance and ensuring it runs efficiently. This code indicates that there is a problem with your car's Mass Air Flow (MAF) sensor, specifically, a Range/Performance issue. The most common cause of P0101 is a bad MAF sensor. My Pearl White Fiat Punto Evo-90 HP - An honest report. First service (check-up) details. The first service was done at Jay-Vijay with odo reading 4600 km on 30th August (the day I got my Team-BHP membership approved ). Engine oil, coolant and wind washer were topped up. Following issues were reported and rectified. 1. Location. Istanbul. May 9, 2020. #9. AndyRKett said: Probably too well, brake cleaner is for brakes, it’s designed to get rid of grease and oil from brake surfaces and will easily strip the oil and lubricants out of the moving parts of your throttle body, the other problem with brake cleaner is it can and will damage electrical components. get the level of clutch fluid checked. once the engine is warm, use the "clutch-switch" to let the engine revs slowly rise - mine goes to @1200 rpm , and the car will pull away with the minimum of fuss, then avoid HARD acceleration, or lugging in taller gears, these put large TORQUE through the clutch.. . Location. Bulgaria. Sep 17, 2014. #1. Hello. I'm owner of a 2010 Punto Evo 1.4 77hp. Most of the times I start the car the red steering wheel light stays on and the message is "Have power steering checked see handbook". The car is not in guarantee anymore. Should you buy a used Punto? Pros and cons, maintenance costs and common problems of the Punto 3.Transmission problems: manual 5 and 6-speed and automated Se Apr 26, 2023. #11. Flashing odometer can be fixed with MultiECUScan, just ask someone near you to run a proxi alignment and it will be ok. Whenever you get the Blue&me fixed, do the same procedure again and it will re-connect to to the system. Afternoon all, Can anyone confirm the type of O2 sensor fitted to the 2010 Fiat Punto Evo turbo Multiair that I am looking at, it has 5 wires going to it so I suspect it is actually a wide band sensor, rather than a standard O2 sensor, and if it is a wide band sensor are any of the OBD2 Apps able to test for voltage I have a number OBD apps but The most common causes for blower motor not working in Fiat Punto are blown fuse, bad relay, resistor or control module malfunction, and faulty blower motor. However, a bad electrical connector or broken wire, or a defect in the climate control unit can also cause the blower motor to stop working. 10.

fiat punto evo common problems